17
ABNORMAL OPERATION
Any of the following are considered to be abnormal operation and may require servicing:
• Yellow tipping of the burner flame. • Burners failing to remain alight.
• Sooting up of cooking utensils. • Burners extinguished by cupboard doors.
• Burners not igniting properly. • Gas valves, which are difficult to turn.
In case the appliance fails to operate correctly, contact Bertazzoni.
SERVICE & MAINTENANCE INSTRUCTIONS
Service and maintenance only to be carried out by an authorised person
Routine maintenance
Have the condition and efficiency of the gas pipe and the pressure regulator (if installed) checked
periodically. If anomalies are found, do not repair components but have the faulty component replaced. To
ensure good performance and safety, the gas regulator taps must be greased periodically.
Periodic lubrication of the taps and any other appliance service must only be carried out by Authorised
Personnel.
To replace parts such as burners, valves and electric components, the hotplate must be removed from the
bench top by releasing the attachment hooks, loosening the attachment screws of each burner, unscrewing
the hotplate attachments nuts which are visible at the bottom of the surface, removing the hotplate top and
finally replacing the defective parts.
Note: if the valves must be replaced, first disassemble the ignitions switches wires.
It is recommended to replace the valve gaskets each time the valve is replaced, thus ensuring a perfect seal
between the body and the gas train.
WARNING: Disconnect power before servicing unit.
WARNING: The power cord supplied with the appliance is connected to the appliance with a type Y
connection (in compliance with standards EN 60335-1, EN 60335-2-6 and subsequent amendments) for
which it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to
avoid a hazard.
WARNING: After first installation of the appliance or after any service intervention concerning main
gas parts of the appliance, make the leak test using water with soap on the gas connections in order
to verify the correct installation. Do not use fire for gas leak testing.
Servicing of an induction unit is to be done by an authorized service agent. Contact your dealer for service
location closest to your residence. Never try servicing the unit yourself.
If any crack on the vitroceramic glass can be noticed, or the glass is broken DO NOT USE THE UNIT.
Disconnect the electrical supply to the unit by tripping the breaker off (if the unit is hard-wired to the supply)
or just unplug the unit (if there is a plug on the supply cable).
(48 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce